Difference between revisions of "Spectrometer"

Revision as of 17:19, 2 November 2020

The MOLLER spectrometer in TOSCA

Layout of the hybrid torus conductor

Review irradiation papers by mid-December
1. Cip, KK, Kent, Juliette
2. Can we live with higher doses on the epoxy than we have been assuming?
3. Do we trust the results?
4. Are the energies/species close enough?

beam pipes and enclosures - are major changes required? - Start mid-December
1. upstream enclosure and pipes (mid-December)
2. clean beam transport due to the SAMs intrusions into the pipe
  1. Cip has a student designing the SAM intrusions
3. aperture in the dump tunnel

Supports at low radius
1. inter-coil supports "under" the envelopes
2. now 2-bounce shield is load bearing?
3. DS torus "2-bounce" not needed, but septapus for shielding

Specifications document
1. KK and Juliette will look at red text
2. We should meet to discuss these

@@ Line 18: / Line 18: @@
     --> float:right; border:1px solid #AA6633"
 |- bgcolor="#fbfeff"
-| [[File:Both toroids.PNG|thumb|upright=2.5|alt=text|The MOLLER spectrometer in TOSCA]]
+| [[File:Both toroids.PNG|thumb|upright=1.5|alt=text|The MOLLER spectrometer in TOSCA]]
 |-
-|[[File:Layout.png|thumb|upright=2.5|alt=text|Layout of the hybrid torus conductor]]
+|[[File:Layout.png|thumb|upright=1.5|alt=text|Layout of the hybrid torus conductor]]
 |}