IntegrationDaq 220826

From Moller Wiki
Jump to: navigation, search

Back to Main Page >> Data Acquisition Meetings >> Integrating mode DAQ meetings

previous meeting << >> following meeting

Meeting information

 Meeting time:  12:00pm Eastern
 
 Zoom connection information
 Join ZoomGov Meeting
 https://jlab-org.zoomgov.com/j/1603800887?pwd=aXVmSnN6aWZWN3RBdXB4RUhGckZJdz09
 
 Meeting ID: 160 380 0887
 Passcode: 903612
 US Tool free phone: (833) 568 8864
 Find your local number: https://jlab-org.zoomgov.com/u/ab8341cjcG

Agenda

  • Activity updates
  • General discussion

Open Issues to be followed up later

  1. Discussions with M. Pitt & J. Musson to understand the beam monitor signals we'll be getting
  2. Draft timing diagram: DocDB 790
  3. Michael, Bob, Brynne, and Paul should put together a list of the integrator running modes we would like to have available

Minutes

Recording at zoomgov: [1]

Participants: W. Gu, P. King, B. Blaikie, B. Moffit, B. Shaw, D. McNulty, D. Bishop, C. Zorn, M. Gericke

  • William has not received the integrator modules yet. Paul will check with Bob about the progress on getting the board in the chassis.
  • Bryerton has received the register information from Bryan which is needed to test the TI-slave functionality. He plans to test it later today
  • Daryl reports that he has not yet done the input-stage modifications for the two boards to be sent to Mainz and to Dustin. He'll get to that next week
  • Michael has received all of the SOMs. He asks about what QA tests he should do.
    • He'll install them one-by-one on the ADC board and then try to boot them up, test the QSFP interfaces, and execute the test pattern mode on the ADCs.
  • Jie has submitted another set of the base+dual amps for fabrication
    • These have some minor changes as compared to the previous round of prototypes.
    • Michael anticipates that this would be the last round of prototypes tested solely at Manitoba. They would go out to other collaborators for further testing and feedback
    • After the meeting, Michael sent an email out to the detector list to see how many to make, and who would like to get some for testing.