Difference between revisions of "IntegrationDaq 210730"
From Moller Wiki
(→Agenda) |
|||
| Line 21: | Line 21: | ||
Templates and examples of design document: http://userweb.jlab.org/~rom/mollerdaq/design | Templates and examples of design document: http://userweb.jlab.org/~rom/mollerdaq/design | ||
| + | |||
| + | == Resources == | ||
| + | === Response from Tom Powers about beamline sample and hold card output === | ||
== Minutes == | == Minutes == | ||
Revision as of 20:47, 28 July 2021
Back to Main Page >> Data Acquisition Meetings >> Integrating mode DAQ meetings
previous meeting << >> following meeting
Meeting information
Meeting time: 3:30pm Eastern BlueJeans calling instructions: Toll-Free Number (U.S.& Canada): 888-240-2560 Other BlueJeans access phone numbers are listed at https://www.bluejeans.com/premium-numbers Bluejeans CODE: 641 252 323 Bluejeans link: https://bluejeans.com/641252323
Agenda
- Progress on prototype
- Requirements document needed. From Jim's message: "we need to get the requirements for trigger/DAQ documented and Rev 0 approved prior to our annual review this fall"
- Follow-up on discussion of input impedance to match beamline signals
- General discussion
Templates and examples of design document: http://userweb.jlab.org/~rom/mollerdaq/design
Resources
Response from Tom Powers about beamline sample and hold card output
Minutes
Recording on Bluejeans.com:
Participants:
