Difference between revisions of "IntegrationDaq 230324"
From Moller Wiki
(Created page with "__NOTOC__ Back to Main Page >> Data Acquisition Meetings >> Integrating mode DAQ meetings In...") |
(→Minutes) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 26: | Line 26: | ||
== Minutes == | == Minutes == | ||
| − | Recording at zoomgov: | + | Recording at zoomgov: [https://jlab-org.zoomgov.com/rec/share/MV6gWtOV-Eiz2pt2uNW9-vDFhGcNNItVQLkAEqpl3DNgcxnI8_XeXHtE7AF2H_Dr.yqfxPA2HDhQGuPIw] |
| − | Participants: | + | Participants: B. Moffit, P. King, R. Michaels, M. Gericke, D. McNulty, C. Cuevas, D. Bishop, J. Pan, S. Chatterjee, C. Zorn, B. Li |
| + | |||
| + | * Activity reports | ||
| + | ** Bryan: The new firmware has been tested, and William verified that the trigger acknowledge is getting back to the TIpcie | ||
| + | ** Daryl: He has the equipment he needs to check the signal integrity on all the ADCs, but hasn't started looking at that yet. | ||
| + | ** Michael: Brynne has gotten set up to do the follow up studies on the bandwidth, but hasn't gotten started yet. | ||
| + | ** Paul and Chris discuss the fiber pull for the TI connection. We'll move forward with a 48-fiber trunk (which gives 12 full MTP QSFP connections available). Paul and Chris are working to get this set up | ||
| + | ** Bob: He had handed off the TIpcie for shipping to Michael | ||
| + | ** Michael | ||
| + | *** All of the ADC chips have been ordered; 435 will be arriving in April, with the remaining 205 will be shipped in September | ||
| + | *** Discussion of the bandwidth of the ADC input stage filter, to make it the limiting factor | ||
| + | **** Daryl says he thinks the amplifier bandwidth is actually a little higher than the 1 MHz of the input stage. | ||
| + | ** Discussion of the long cables | ||
| + | *** Jie had used cables of 100m in the bench testing; Dustin says that the path is likely to be about 75m, so testing with 100m should be sufficient | ||
| + | *** Michael will suggest to Brynne to take a look at the bandwidth with both short cables and the 100m cable to see what impact that has | ||
Latest revision as of 13:56, 7 April 2023
Back to Main Page >> Data Acquisition Meetings >> Integrating mode DAQ meetings
previous meeting << >> following meeting
Meeting information
Meeting time: 12:00pm Eastern Zoom connection information Join ZoomGov Meeting https://jlab-org.zoomgov.com/j/1603800887?pwd=aXVmSnN6aWZWN3RBdXB4RUhGckZJdz09 Meeting ID: 160 380 0887 Passcode: 903612 US Tool free phone: (833) 568 8864 Find your local number: https://jlab-org.zoomgov.com/u/ab8341cjcG
Agenda
- Activity updates
- General discussion
Open Issues to be followed up later
- Discussions with M. Pitt & J. Musson to understand the beam monitor signals we'll be getting
- Draft timing diagram: DocDB 790
- Michael, Bob, Brynne, and Paul should put together a list of the integrator running modes we would like to have available
Minutes
Recording at zoomgov: [1]
Participants: B. Moffit, P. King, R. Michaels, M. Gericke, D. McNulty, C. Cuevas, D. Bishop, J. Pan, S. Chatterjee, C. Zorn, B. Li
- Activity reports
- Bryan: The new firmware has been tested, and William verified that the trigger acknowledge is getting back to the TIpcie
- Daryl: He has the equipment he needs to check the signal integrity on all the ADCs, but hasn't started looking at that yet.
- Michael: Brynne has gotten set up to do the follow up studies on the bandwidth, but hasn't gotten started yet.
- Paul and Chris discuss the fiber pull for the TI connection. We'll move forward with a 48-fiber trunk (which gives 12 full MTP QSFP connections available). Paul and Chris are working to get this set up
- Bob: He had handed off the TIpcie for shipping to Michael
- Michael
- All of the ADC chips have been ordered; 435 will be arriving in April, with the remaining 205 will be shipped in September
- Discussion of the bandwidth of the ADC input stage filter, to make it the limiting factor
- Daryl says he thinks the amplifier bandwidth is actually a little higher than the 1 MHz of the input stage.
- Discussion of the long cables
- Jie had used cables of 100m in the bench testing; Dustin says that the path is likely to be about 75m, so testing with 100m should be sufficient
- Michael will suggest to Brynne to take a look at the bandwidth with both short cables and the 100m cable to see what impact that has
