View source for IntegrationDaq 230324

__NOTOC__
Back to [[Main_Page|Main Page]] >>  [[DAQ Meetings|Data Acquisition Meetings]] >>  [[DAQ Meetings#Integrating mode DAQ meetings|Integrating mode DAQ meetings]]

[[IntegrationDaq_230310 | previous meeting]] <<   >> [[IntegrationDaq_230407 | following meeting]]

== Meeting information ==
  '''Meeting time:'''  12:00pm Eastern
  
  Zoom connection information
  Join ZoomGov Meeting
  https://jlab-org.zoomgov.com/j/1603800887?pwd=aXVmSnN6aWZWN3RBdXB4RUhGckZJdz09
  
  Meeting ID: 160 380 0887
  Passcode: 903612
  US Tool free phone: (833) 568 8864
  Find your local number: https://jlab-org.zoomgov.com/u/ab8341cjcG

== Agenda ==
*  Activity updates
*  General discussion

=== Open Issues to be followed up later ===
# Discussions with M. Pitt & J. Musson to understand the beam monitor signals we'll be getting
# Draft timing diagram: [https://moller.jlab.org/cgi-bin/DocDB/public/ShowDocument?docid=790 DocDB 790]
# Michael, Bob, Brynne, and Paul should put together a list of the integrator running modes we would like to have available

== Minutes ==
Recording at zoomgov:  [https://jlab-org.zoomgov.com/rec/share/MV6gWtOV-Eiz2pt2uNW9-vDFhGcNNItVQLkAEqpl3DNgcxnI8_XeXHtE7AF2H_Dr.yqfxPA2HDhQGuPIw]

Participants:  B. Moffit, P. King, R. Michaels, M. Gericke, D. McNulty, C. Cuevas, D. Bishop, J. Pan, S. Chatterjee, C. Zorn, B. Li

*  Activity reports
**  Bryan:  The new firmware has been tested, and William verified that the trigger acknowledge is getting back to the TIpcie
**  Daryl:  He has the equipment he needs to check the signal integrity on all the ADCs, but hasn't started looking at that yet.  
**  Michael:  Brynne has gotten set up to do the follow up studies on the bandwidth, but hasn't gotten started yet.
**  Paul and Chris discuss the fiber pull for the TI connection.  We'll move forward with a 48-fiber trunk (which gives 12 full MTP QSFP connections available).  Paul and Chris are working to get this set up
**  Bob:  He had handed off the TIpcie for shipping to Michael
**  Michael
***  All of the ADC chips have been ordered; 435 will be arriving in April, with the remaining 205 will be shipped in September
***  Discussion of the bandwidth of the ADC input stage filter, to make it the limiting factor
****  Daryl says he thinks the amplifier bandwidth is actually a little higher than the 1 MHz of the input stage.
**  Discussion of the long cables
***  Jie had used cables of 100m in the bench testing; Dustin says that the path is likely to be about 75m, so testing with 100m should be sufficient
***  Michael will suggest to Brynne to take a look at the bandwidth with both short cables and the 100m cable to see what impact that has