CountingDaq 201209

From Moller Wiki
Revision as of 20:21, 5 January 2021 by Pking (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Back to Main Page >> Data Acquisition Meetings >> Counting mode DAQ meetings

previous meeting << >> following meeting

Meeting information

 Meeting time:  2:00pm Eastern
 BlueJeans calling instructions:
 Toll-Free Number (U.S.&  Canada):  888-240-2560
 Other BlueJeans access phone numbers are listed at
 Bluejeans CODE:                    411 309 650 
 Bluejeans link:


  • Brief review of conceptual design: [1]
    • Full DAQ talk from May 2020 collaboration meeting: DocDB 602
  • General discussion


Participants: R. Michaels, H. Liu, D .Armstrong, B. Moffit, P. King

  • DA points out that with all 7 sectors instrumented with GEMS & scintillators, plus two pion detector sectors, we will have 18 trigger scintillator signals
    • We will need to add another FADC and discriminator to the plan to accommodate the added PMTs
  • BM recommends replacing the TS+TD in VXS crate #3 by a TI-master. He also recommends shifting the MPD modules to a separate crate (can be a basic VME, and may not need a CPU) and adding more SSP modules to make the GEM readout faster.
    • To have a better feel for this, we need to get some more information about the GEM readout parameters. PK has sent a message to Nilanga to get some feedback from him
  • Discussion about triggering modes
    • At ~100nA (roughly 30 MHz/sector), we'd probably run a pulser trigger and find "good hits" in the analysis. BM says that the TI has an internal pulser trigger and an internal random trigger.
    • At ~100pA (roughly 30 kHz/sector), we would likely use the detector-based triggering