Difference between revisions of "December 09, 2021"
From Moller Wiki
(→Meeting Disgust) |
(→Meeting Disgust) |
||
| Line 10: | Line 10: | ||
== Meeting Disgust == | == Meeting Disgust == | ||
# Project background | # Project background | ||
| − | #* | + | #* Stonybrook is assigned to construct 12 out of the 28 layers of GEM trackers for the Moller experiment |
| − | # | + | #* Two prototype trackers to be constructed by late 2022. GEM material (three rectangular sheets) will arrive SBU in early March; frames will arrive later |
# | # | ||
| + | # | ||
| + | # Sub-tasks (required volunteers, or will be assigned): | ||
| + | #* Clearing out a perimeter in the basement lab, and setting up the cleanroom. | ||
| + | #* Setting latest JLAb DAQ system: CODA, and configure it to be used for calibrating the prototype GEM trackers | ||
| + | #* | ||
| + | #* Setting | ||
| + | #* | ||
| + | #* Manufacturing stage: | ||
| + | #** Manufacturing/stretching GEM sheet and mount to bracket (with glue) inside the clean room (Klaus and Prakhar) | ||
| + | #* Calibration stage: | ||
| + | #** Manufacturing/stretching GEM sheet and mount to bracket (with glue) inside the clean room (Klaus and Prakhar) | ||
# | # | ||
| + | # Additional equipment needed: | ||
| + | #* Cleanroom | ||
| + | #* Gas system? CO2 and Helium mixture | ||
| + | #* X-Ray gun mounted on arms that move in small stepped | ||
Revision as of 19:35, 9 December 2021
Meeting Information
GEM @ Stonybrook Meeting
Wednesday December 08, 2021
3:30 pm, ET
Agenda
- Kicking off the Gem work planning at Stonybrook.
Meeting Disgust
- Project background
- Stonybrook is assigned to construct 12 out of the 28 layers of GEM trackers for the Moller experiment
- Two prototype trackers to be constructed by late 2022. GEM material (three rectangular sheets) will arrive SBU in early March; frames will arrive later
- Sub-tasks (required volunteers, or will be assigned):
- Clearing out a perimeter in the basement lab, and setting up the cleanroom.
- Setting latest JLAb DAQ system: CODA, and configure it to be used for calibrating the prototype GEM trackers
- Setting
- Manufacturing stage:
- Manufacturing/stretching GEM sheet and mount to bracket (with glue) inside the clean room (Klaus and Prakhar)
- Calibration stage:
- Manufacturing/stretching GEM sheet and mount to bracket (with glue) inside the clean room (Klaus and Prakhar)
- Additional equipment needed:
- Cleanroom
- Gas system? CO2 and Helium mixture
- X-Ray gun mounted on arms that move in small stepped
