View source for IntegrationDaq 220603

__NOTOC__
Back to [[Main_Page|Main Page]] >>  [[DAQ Meetings|Data Acquisition Meetings]] >>  [[DAQ Meetings#Integrating mode DAQ meetings|Integrating mode DAQ meetings]]

[[IntegrationDaq_220520 | previous meeting]] <<   >> [[IntegrationDaq_220617 | following meeting]]

== Meeting information ==
  '''Meeting time:'''  12:00pm Eastern
  
  Zoom connection information
  Join ZoomGov Meeting
  https://jlab-org.zoomgov.com/j/1603800887?pwd=aXVmSnN6aWZWN3RBdXB4RUhGckZJdz09
  
  Meeting ID: 160 380 0887
  Passcode: 903612
  US Tool free phone: (833) 568 8864
  Find your local number: https://jlab-org.zoomgov.com/u/ab8341cjcG

== Agenda ==
*  Activity updates
*  General discussion

=== Open Issues to be followed up later ===
# Discussions with M. Pitt & J. Musson to understand the beam monitor signals we'll be getting
# Draft timing diagram: [https://moller.jlab.org/cgi-bin/DocDB/public/ShowDocument?docid=790 DocDB 790]
# Michael, Bob, Brynne, and Paul should put together a list of the integrator running modes we would like to have available

== Minutes ==
Recording at zoomgov:  [https://jlab-org.zoomgov.com/rec/share/-jVDe7ea9rfIzMS5NVP51Xm9R4VqA4RwvnCwlfLLw0ULz_lwphkJDVnm8JV3gj56.4C6qeYOvjXPB5wmC?startTime=1654271674000]

Participants:  B. Shaw, C. Zorn, R. Michaels, B. Moffit, B. Blaikie, M. Gericke, D. Bishop, J. Pan, W. Gu, P. King

*  Bryerton:  He was working on other projects so didn't put much work in on the ADC
**  He has received the TI routines from Bryan and William, but hasn't had a chance to work on it yet.
**  Some reworking of the kernel modules and DMA code
**  He has ordered the Comblock 10Gig IP
*  Bob:  There is some operations money available that he plans to use to set up the digital BCM project and the polarimeter DAQ systems
*  Michael
**  The ADC worked really well at the beamtest
**  The replacement amps for the ADC boards are likely arriving in August, so that's when the boards would become available
**  The PoE was really nice to work with, and so we might use that for the installed ADCs also; we'll need to think about how this might impact our grounding plan
**  The standard ethernet will be used for slow controls too; the main data transfer will be through the QSFP though
**  The preamplifiers had noise coming from both DC-DC converters and a potentiometer for adjusting gains/offsets
***  We'll need careful definition of power supplies, and to use fixed gain resistors to avoid both of these.
*  Brynne:  Shows photos of the new PMT support system